Receptacle A KS-113 30 M2-R Item KS-11330M2-R

Downloads
Conformation of RoHS compliance (EN|PDF)
Product datasheet (EN|pdf)
CAD file (INGUN_KS-113_30_M2-R.STEP)
Choose version
KS-113 30 M2-R (KS-11330M2-R) INGUN SELECTION
KS-113 30 M2-T (KS-11330M2-T) INGUN SELECTION KS-113 30 M2-R-Z (KS-11330M2-R-Z) KS-113 30 M2-R (KS-11330M2-R) INGUN SELECTION KS-113 30 M2 (KS-11330M2) INGUN SELECTION KS-113 30 M2-R-S (KS-11330M2-R-S) INGUN SELECTION
Here you can optionally configure a new variant:
Technical data
General data
Product group : Receptacles (KS)
Series : KS-113
Sub-series : KS-113 M screw-in version
Type of receptacle connection : Solder
Press ring : No
Surface area : Gold
Collar diameter : 3.2 mm
Collar height : 0.2 mm
Knurl : Yes
Vacuum-tight : No
RoHS-compliant : RoHS-3;6c
Mounting hole
Mounting hole in CEM1 : 3.00 - 3.02 mm
Mounting hole in FR4 : 3.00 - 3.02 mm
Mechanical data
Total length : 27 mm
Outer diameter : 3 mm

Test probes for installation height, Test probes

Step probe T-113 M
  • Step probes are used to test the correct position of the contact terminals (contact lamellae) in the plug housings. A connection test can be carried out at the same time. Contact will only occur when the tip of the step probe is correctly positioned
  • For optimum contacting, various tip styles are available in various tip ø, disc ø and pin lengths
High-current probe HSS-120 M
  • Trusted high-current probes, optimally sized for current load capacity ratio
  • Low resistance probe with Ri typical: < 10 mOhm
  • For use in function and burn-in tests
  • Large selection of tip styles and spring forces for optimum contact with DUT
  • Secure contact receptacle thanks to screw thread
Step probe T-888 M
  • Step probes are used to test the correct position of the contact terminals (contact lamellae) in the plug housings. A connection test can be carried out at the same time. Contact will only occur when the tip of the step probe is correctly positioned
  • For optimum contacting, various tip styles are available in various tip ø, disc ø and pin lengths
  • Version for test probes installed particularly close together: the screw-in torque is applied via the disc using a bit tool
Spring-loaded test probe GKS-113 M
  • Screw-in test probes for applications with possible vibrations or unwanted side and axial forces (migration of the test probe out of the receptacle is reliably prevented)
  • The screw-in test probe is securely installed in the KS using a torque screwdriver and bit tool. The required screw-in torque is applied via a square post on the receptacle.
  • Stainless steel versions for temperatures from -100 °C up to +200 °C available