Customising accessory
Sort by:
Products found:
77
View:
INGUN SELECTION
Board marker probe
ME-E
- Marking type: Circle
- Surface material: Hard / soft
- Accessory type: Customising accessory
- Version: Electrical
Cleaning mat
KRM
- Accessory type: Cleaning accessories
- Type: Mat 2.3 mm
- Version: ESD charging possible
- Useable area (WxD): 550 x 450 mm
Adapter sleeve board marker
ADH
- Accessory type: Customising accessory
- Type: Adpater sleeve
- Version: Threaded nut with collar
Ground plate
MAP
- Accessory type: Customising accessory
- Type: With print
- Version: One-sided, copper plated
Interface block
SB-SI
- Accessory type: Customising accessory
- Type: Signal block
- Version: Device under test (DUT) side
- Component assembly: KT-158 06 (posts)
Interface block
SB-VA
- Accessory type: Customising accessory
- Type: Vacuum flange
- Version: Device under test (DUT) side
- Component assembly: 1, fully loaded
INGUN SELECTION
DUT support
PAS
- Accessory type: Customising accessory
- Type: DUT support (round)
- Version: Suitable for ESD-protected zone
- Tip diameter: 5 mm
INGUN SELECTION
Push rod
NHS-ST
- Accessory type: Customising accessory
- Type: Starr
- Version: Not ESD compliant
- Total length: 60 mm
Pre-centring pin
VZ
- Accessory type: Customising accessory
- Type: Pre-centring pin, round, centric
- Version: Not ESD compliant
Tooling pin
FS-ST
- Accessory type: Customising accessory
- Type: Round
- Version: ADP, 4 mm thick
- Tip diameter: 2.3 mm
INGUN SELECTION
Guide bush
FU
- Accessory type: Customising accessory
- Type: Guide bush
- Version: With collar 1 x d15 mm