PET AT customizing accessories

PET AT customizing accessories - side approach mechanism PET AT customizing accessories - screwing unit PET AT customizing accessories - toolin pins PET AT customizing accessories - starter kits PET AT customizing accessories - cleaning mats PET AT customizing accessories - board marker probes PET AT customizing accessories - push rods PET AT customizing accessories - opens-test PET AT customizing accessories - dut-supports PET AT customizing accessories - receiver PET AT customizing accessories - interface blocks PET AT customizing accessories - button activators PET AT customizing accessories - prE-centering pins PET AT customizing accessories - miscellaneous

Filter

Filter groups

Sort by:
Products found: 67
View:
INGUN SELECTION ME-E
Board marker probe   ME-E
  • Marking type: Circle
  • Surface material: Hard / soft
  • Accessory type: Customising accessory
  • Version: Electrical
Open versions
KRM
Cleaning mat KRM
  • Accessory type: Cleaning accessories
  • Type: Mat 2.3 mm
  • Version: ESD charging possible
  • Useable area (WxD): 550 x 450 mm
Open versions
MAP
Ground plate MAP
  • Accessory type: Customising accessory
  • Type: With print
  • Version: One-sided, copper plated
Open versions
ADH
Adapter sleeve board marker ADH
  • Accessory type: Customising accessory
  • Type: Adpater sleeve
  • Version: Threaded nut with collar
Open versions
SB-SI
Interface block SB-SI
  • Accessory type: Customising accessory
  • Type: Signal block
  • Version: Coding block, signal block
  • Component assembly: 25 x KT-158 (posts)
Open versions
HF-U
RF transfer HF-U
  • Accessory type: Customising accessory
  • Type: D-sub plug connector
  • Version: RF transfer
  • Connection: Wire-wrap posts
Open versions
FB-WS
Top moving plate with accessories FB-WS
  • Accessory type: Customising accessory
  • Type: Top side contacting
  • Version: ESD
Open versions
SB-VA
Interface block SB-VA
  • Accessory type: Customising accessory
  • Type: Vacuum flange
  • Version: Device under test (DUT) side
  • Component assembly: 1, fully loaded
Open versions
INGUN SELECTION PAS
DUT support PAS
  • Accessory type: Customising accessory
  • Type: DUT support (round)
  • Version: Suitable for ESD-protected zone
  • Tip diameter: 5 mm
Open versions
INGUN SELECTION NHS-ST
Push rod NHS-ST
  • Accessory type: Customising accessory
  • Type: Starr
  • Version: Not ESD compliant
  • Total length: 60 mm
Open versions
VZ
Pre-centring pin VZ
  • Accessory type: Customising accessory
  • Type: Pre-centring pin, round, centric
  • Version: Not ESD compliant
Open versions
FED
Pressure spring FED
  • Accessory type: Customising accessory
  • Type: Pressure spring
Open versions