The new board marker probe from INGUN allows PCBs that have been tested and found to be “good” to be marked reliably. This high quality product boasts an impressive compact design and a high degree of flexibility in customisation. An exchangeable engraving unit makes replacing worn engraving units quick and easy as tools are not required.
The compact board marker probe (marking unit) from INGUN allows PCBs, non-hardened metals or electrical units that have been tested and found to be “good” to be marked reliably. A circle with a diameter of 2 mm is permanently engraved on the device under test (DUT). The marking units are available as an accessory for self-customisation or, upon request, can be integrated in an INGUN customised test fixture. The new electrical board marker probe offers an impressive multitude of performance features. The particularly small dimensions save a significant amount of space in fixture customisation. A continuous outer thread ensures precise, adjustable positioning. The board marker probe consist of two components: the receptacle and the engraving unit. This design makes replacing worn engraving units quick and easy as tools are not needed and the receptacle remains installed in the test fixture. This quick-exchange system results in time and cost savings in the test process. A wide operating voltage range of 6 to 42 VDC with reverse polarity protection ensures simple and safe use with all common test systems. In contrast to conventional connection methods, the plug-in connection allows the marking unit cables to be disconnected without damage. The marking units are available as an accessory for self-customisation or, upon request, can be integrated in an INGUN customised test fixture.
Benefits at a glance: